Working Hunter

Working Hunter Show - LEAGUE POINTS - ESUK Qualifiers

Working Hunter consisting of 8 working hunter fences followed by a ridden show piece. In the interest of horse welfare we are only allowing two consecutive jumping classes to be entered. Working Hunter rules require smart, plain, workmanlike tack and correct rider attire, with plaited manes and tails, and standard riding jackets. Competitors must present a clean and well-turned-out horse, use boots for the jumping phase only (which must be removed for the ridden judging), and adhere to regulations regarding whips and spurs. Tack cannot be changed between phases, and safety is paramount. Tack and Horse Presentation Tack: Should be plain, dark brown or black leather. Avoid excessive "bling," decorative details, or non-standard colours. Bridles and Bits: Plain bridles are best. Any bit and noseband suitable for the horse are allowed. Martingales: Running martingales are acceptable. Boots: Dark brushing boots are allowed for the jumping phase but must be removed for the conformation and ridden phases. Mane and Tail: Manes are typically plaited, and tails should be pulled. Grooming: The horse and pony should be tidy, with ears and jawlines clean. Numnahs: These should match the tack and be small, not interfering with the saddle's fit. Rider Attire Attire: Riders typically wear a smart tweed jacket, plain tie or stock, pale shirt, cream or canary jodhpurs, and long boots. Hair: Long hair must be in a net or tied back to prevent it from getting in the way. Jewellery: Other than stud earrings, jewellery should be avoided. Body Protectors: Body protectors are often recommended and may be compulsory in pony working hunter classes; they should be worn under the jacket for presentation. Jumping Phase Course: The course consists of natural fences found in a countryside setting. Tack Changes: No changes in tack are allowed after the jumping phase, except for the removal of protective boots. Faults: Dropping a rail, a fall from the horse or rider, or refusing a fence results in elimination. Ridden (Flat) Phase Assessment: The horse is judged on rideability and obedience. Tack: The tack used during the jumping phase must remain on. Other Regulations Whips and Spurs: Whips must not exceed 30 inches, and spurs are not permitted in working hunter pony classes. Competitor Conduct: Acts of disrespect towards judges or officials can lead to disqualification. Disqualification: A fall of horse or rider during the jumping phase will result in elimination from the class.

Entries are available Choose everything you need, then complete one secure checkout.
Enter this event

Classes

9 classes

Saturday 14 November 2026

1
Lead Rein - riders 9yrs & under, not exceeding 12.2 hh
10:00 AM Main Arena Single Phase + Showing
£10.00Open
2
Cradle/Nursery Stakes - Riders 12yrs & under, not exceeding 13.2hh
Main Arena Single Phase + Showing
£12.00Open
3
40cm Horse/Pony
Main Arena Single Phase + Showing
£12.00Open
4
50cm Horse/Pony
Main Arena Single Phase + Showing
£12.00Open
5
60cm Horse/Pony
Main Arena Single Phase + Showing
£12.00Open
6
70cm Horse/Pony
Main Arena Single Phase + Showing
£12.00Open
7
80cm Horse/Pony
Main Arena Single Phase + Showing
£12.00Open
8
90cm Horse/Pony
Main Arena Single Phase + Showing
£12.00Open
9
100m Horse/Pony
Main Arena Single Phase + Showing
£12.00Open

About this event

Information from Blidworth Equestrian Show Centre.

Working Hunter consisting of 8 working hunter fences followed by a ridden show piece. In the interest of horse welfare we are only allowing two consecutive jumping classes to be entered. Working Hunter rules require smart, plain, workmanlike tack and correct rider attire, with plaited manes and tails, and standard riding jackets. Competitors must present a clean and well-turned-out horse, use boots for the jumping phase only (which must be removed for the ridden judging), and adhere to regulations regarding whips and spurs. Tack cannot be changed between phases, and safety is paramount. Tack and Horse Presentation Tack: Should be plain, dark brown or black leather. Avoid excessive "bling," decorative details, or non-standard colours. Bridles and Bits: Plain bridles are best. Any bit and noseband suitable for the horse are allowed. Martingales: Running martingales are acceptable. Boots: Dark brushing boots are allowed for the jumping phase but must be removed for the conformation and ridden phases. Mane and Tail: Manes are typically plaited, and tails should be pulled. Grooming: The horse and pony should be tidy, with ears and jawlines clean. Numnahs: These should match the tack and be small, not interfering with the saddle's fit. Rider Attire Attire: Riders typically wear a smart tweed jacket, plain tie or stock, pale shirt, cream or canary jodhpurs, and long boots. Hair: Long hair must be in a net or tied back to prevent it from getting in the way. Jewellery: Other than stud earrings, jewellery should be avoided. Body Protectors: Body protectors are often recommended and may be compulsory in pony working hunter classes; they should be worn under the jacket for presentation. Jumping Phase Course: The course consists of natural fences found in a countryside setting. Tack Changes: No changes in tack are allowed after the jumping phase, except for the removal of protective boots. Faults: Dropping a rail, a fall from the horse or rider, or refusing a fence results in elimination. Ridden (Flat) Phase Assessment: The horse is judged on rideability and obedience. Tack: The tack used during the jumping phase must remain on. Other Regulations Whips and Spurs: Whips must not exceed 30 inches, and spurs are not permitted in working hunter pony classes. Competitor Conduct: Acts of disrespect towards judges or officials can lead to disqualification. Disqualification: A fall of horse or rider during the jumping phase will result in elimination from the class.

First aid: First Aider on site TBC

Refund policy: No refund given if cancelled within 24 hrs